If a router is totally maxed out on the outside interface, I'm able to telnet but the cli is choppy at times. Is creating a control-plane policy the best way to handle incoming telnet traffic? I've never done one of these before....
In this situation (happened all the time to me in the past), you need to use CBWFQ to create a class called Mgt Class. And then assign telnet, SSH, NTP, etc to that Class so that any management traffic can be protected during high bandwidth utilization period.
Most of the transit traffic is CEF switched so there should not be any high CPU utilization.
Unfortunately, I think it was just conincidental that the packages that were being pushed were paused. I'm back to square one now that they're starting to use the bandwidth again. Any other suggestions?
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...