Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

controller card issues

I have a issue where im trying to install a vwic-1mft-g703 card in a 1841 router. The router doesnt seem to recognise the controller when I go into interface mode. But from what i can see you can fo into configuration and then to card type which is e1. At the end of the config command you are presented with 0-0 card slot number. I just need some help as what ever slot number i enter it doesnt recognise it

Any help will be gladly appreicated

2 REPLIES

Re: controller card issues

Hi

Can you give the output of

"sh ver"

"sh diag"

"sh run"

Regards

JD

Re: controller card issues

hi

can you post the output of show verion and show controller commands here?

regds

117
Views
0
Helpful
2
Replies