Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Converting e1 bnc to rj45 ??

Hello,

I need help in converting my E1 internet connection to my router. 

I have a  modem from my isp which has two bnc connections.... one labeled "in" and one labeled "out" both at E1 75 ohms...

I have a cisco router with an E1 Wic card installed (rj45)...

I need to convert the signal.  I have a balun and a 10 base2 to 10 baset converter.

I have tried both individually and am not getting results.

Am I on the right track?? is there something anyone can suggest?? or where to purchase it??

I would really appreciate any help.

Thanx.....Omar

1 ACCEPTED SOLUTION

Accepted Solutions
Community Member

Re: Converting e1 bnc to rj45 ??

VWIC2-1MFT-T1/E1    - 1 PORT RJ-48   MULTIFLEX TRUNK - T1/E1

3 REPLIES
Hall of Fame Super Gold

Re: Converting e1 bnc to rj45 ??

Which card do you have? send "show diag".

Community Member

Re: Converting e1 bnc to rj45 ??

VWIC2-1MFT-T1/E1    - 1 PORT RJ-48   MULTIFLEX TRUNK - T1/E1

Hall of Fame Super Gold

Re: Converting e1 bnc to rj45 ??

You do not need a balun.

Under controller  E1, configure line-termination 75.

Then make an appropriate cable, or buy the cisco one.

Please remember to rate useful post clicking on the stars below.

1721
Views
5
Helpful
3
Replies
CreatePlease to create content