Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Converting external CSU to internal CSU

I have T1 connection. 17 channels for data. The remaining 7 for voice. I have a Paradyne external CSU at each end. What kind of Cisco internal module could I use to replace these Paradyne CSUs and do have example of the configuration. I am pretty sure I would use a VWIC-2MFT-T1-DI but I can't figure out how I configure the voice to go out the second interface connecting the PBX.

2 REPLIES
Silver

Re: Converting external CSU to internal CSU

check out if the following link on Understanding Support for Voice and Data on 2600/3600 Series Routers helps :

http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a0080100688.shtml

Silver

Re: Converting external CSU to internal CSU

Use the 2nd generation card VWIC2-2MFT-T1/E1 for total flexability. The doc you need to configure this card is in the relevant IOS guide.

Although not as exhaustive, one helpful page for config is:

http://www.cisco.com/en/US/customer/products/hw/modules/ps2617/products_configuration_example09186a008052c920.shtml

More info:

http://www.cisco.com/en/US/customer/products/ps5855/products_qanda_item0900aecd8028d2e5.shtml

HTH pls rate!

99
Views
8
Helpful
2
Replies
CreatePlease login to create content