hello all. Today when I was making some changes to my core router, I accidently fat fingered the copy run start command at the end to save my config. I accidently typed "copy run start5" and now every time I do a copy run start, the router is asking me to confirm destination file name [start]? rather than [startup-config]. The weird part is when I tab the entire command out, it saves the config to the startup-config. Can someone please help me out? I want to remove the file i created I think and when i issue the copy run start command, I want it to be saved into the correct directory. I know this sounds confusing but can someone please give me a hand here? Thank you!
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...