Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

CoS Configuration on router

Hi,

I have a request to configure CoS on a cisco router that is been provisioned for an MPLS Circuit with following requirements for the WAN interface on the router.

1. Commit 2048Kbps with DSCP 46

2. Commit 1024Kbps with DSCP 26

How to I set this up on the interface of the router for both input and output traffic?

Thanks

Nki

1 REPLY
Cisco Employee

Re: CoS Configuration on router

Hi Nki,

Router doesn't queue traffic on ingress direction, only process switched packets will be put in input queue. Assume traffic are marked correctly in your LAN network (DSCP 46/26), then you can simply create classes to match the DSCP and assign the bandwidth to each class. Please refer the QoS design guide for configuration example:

http://www.cisco.com/en/US/docs/solutions/Enterprise/WAN_and_MAN/QoS_SRND/WANQoS.html

HTH,

Lei Tian

477
Views
0
Helpful
1
Replies
CreatePlease to create content