Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Could you help me about easy vpn .

Dear all,

could you help me about easy vpn.

now from the picture client @ branch site can access server  @ HQ site via local ip from vpn connection. but server @ site can not access to client local ip address.

i attach picture for this could you please advice about configuration.

Many thank for kindly support.

Everyone's tags (2)
5 REPLIES
New Member

Re: Could you help me about easy vpn .

now i re-config until the tunnel connect

BLP-MK#sh crypto sess

Crypto session current status

Interface: Dialer0

Session status: UP-ACTIVE    

Peer: 180.180.246.229 port 500

  IKEv1 SA: local 180.183.235.18/500 remote 180.180.246.229/500 Active

  IPSEC FLOW: permit ip 10.33.103.0/255.255.255.0 10.0.254.0/255.255.255.0

        Active SAs: 2, origin: crypto map

but i can not connect from client @ brand to server @ HQ

Could you please advice my config

Could you help me about easy vpn .

Hello.

Regarding your original configuration:

On the client side you need to change mode to "network-ext".

Current mode "client" is some sort of NAT into IP-address client received from EzVPN server.

But my concern is your NAT configuration.

You need to review NAT and ensure that inter-site traffic is never NATed.

New Member

Re: Could you help me about easy vpn .

thank you for kindly support.

first i think i don't have static ip @ client side so i use ezvpn. but when i try to use ipsec with dynamic. because i don't want to use nat.

now i use the new configuration. if i want to use only routing. Can i connect to Local IP address for both side without NAT.

could you advise my configuration.

Re: Could you help me about easy vpn .

Hello, Siriphan.

Could you please clarify your requirements?

Is branch's WAN IP-address public (or private)?

Is branch's WAN IP-address static (or dynamic)?

How many sites do you have?

Do you have any other requirement for the design?

Why do you use that strange configuration mixing public and internal IP-addresses:

interface GigabitEthernet0/1

description LAN Link to LAN-Network

ip address 10.0.254.254 255.255.255.0 secondary

ip address 180.180.246.229 255.255.255.252

Why do you apply crypto map (HQ device) on G0/0, but default route goes via G0/0.

Do you configure real devices (or it's your lab)?

Re: Could you help me about easy vpn .

Regarding your new config: does you client has static IP-address?

Or it's changing every time you reconnect?

If it's static and public (not from RFC1918) then it's better to configure VTI.

How many branches do you have?

Why do you use Easy VPN?

332
Views
10
Helpful
5
Replies
CreatePlease to create content