cross connect voice robbit signaling. ds0 group to ds0 group
I am trying to use a cisco 2431 as a basic csu with drop and insert capabilities, but am having problems with the ckt passing Robbit signaling. Any ideas? below is my config.....
1. a network t1 comming in 1-8 and ch 24 (for a PRI) pointed out t1 1/0. Channels 9-23 are loop start lines connected to a PBX.
2. a MFT1 Drop and insert card (2port) in slot 0. -xcon within the same card.
3. software (C2430-IK9O3S-M),12.4(8)ver
When I use the command tdm-group x timeslots 9-23 type fxs loop-start under both controllers then cross connect them via the command "connect" the signalling will not pass. If I set up these as ds0 groups there is no way to cross-connect them. Any ideas?
Re: cross connect voice robbit signaling. ds0 group to ds0 group
If connection is by means of a straight cable replace it with crossover cable.T1 cross-over to test (1-4, 2-5) pairs.Check the clocking configured on the interface with PBX provider.Below is the example configuration
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.