Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

crossover between 3550's failing

I noticed my port lights are not illuminated on two 3550's connected together at port 12 via a xover cable (tried a new cable same problem), ...any ideas?

Thx.

5 REPLIES
New Member

Re: crossover between 3550's failing

I have the following setup for xover port 12;

No Switchport

No IP address

shutdown

duplex full

Silver

Re: crossover between 3550's failing

The interface is shut. did u try unshut the interface ....... ?

Regds

New Member

Re: crossover between 3550's failing

How do you restart an interface (3550 ios 12.1 (22))?

Re: crossover between 3550's failing

Hi

it would be ideally no shutdown command which will enable the interface.

hope u are aware the procedure on how to get onto the interface level mode where you keyin this command..

regds

Re: crossover between 3550's failing

Hi

it would be ideally no shutdown command which will enable the interface.

hope u are aware the procedure on how to get onto the interface level mode where you keyin this command..

regds

135
Views
0
Helpful
5
Replies
CreatePlease login to create content