/sh int/ on MLP Bundle interface shows 100% input errors
Symptom: on a multilink bundle interface, the output from "show interface" will show an input error count which includes essentially 100% of the traffic being received. Other drop counters, usually the "bad frame" counter, are also incremented to match.
# show interface Multilink1
Multilink1 is up, line protocol is up
Hardware is multilink group interface
Internet address is 10.20.0.1/30
MTU 1500 bytes, BW 3072 Kbit, DLY 100000 usec,
reliability 181/255, txload 1/255, rxload 1/255
Encapsulation PPP, LCP Open, multilink Open
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
6080 packets input, 1027997 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
Impact: Very Low. This is an accounting error; the counters are being accidentally incremented each time Multilink begins to receive a new datagram. This does not affect actual traffic flow or operation of the bundle, it is only the statistics that are in error.
My Router Reliability Status:
Router#sh int Mu 1 | in reliability
reliability 140/255, txload 23/255, rxload 86/255
What is meant by an "accounting error" that has been described in the BUG details.
Can someone please provide some Recommendation on this BUG. What is the next course of Action should i take forward ?
show Log for your Reference:
The Input Errors are continuously increasing but the CISCO Bug says it doesnot affect the actual traffic flow or operation of Bundle.
How do i get it confirmed that my actual traffic is not getting impacted ? Is there any possible way to verify the same.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...