CWM SNMP Agent: Modifying ATM-Fr middle end point parameters?

jbocanegra · ‎11-24-2005

Hi,

I've been unsuccessfully trying to modify parameters for svConnMiddlEndPt on a ATM-FR connection between a BPX 8620 and a MGX 8230. Syntax seems to be correct, for I can thus modify parameters on the ATM 'final' end point:

bash$ snmpset -p 8161 localhost private atmEndPointSCRZeroPlus1.6.65.66.73.45.66.49.0.1.1.1.1 i 50

Error in packet.

Reason: (genError) A general failure occured

Failed object: enterprises.stratacom.svplus.serviceGroup.connGroup.atmEndPointTable.atmEndPointEntry.atmEndPointSCRZeroPlus1."ABI-B1"."".1.1.1.1

bash$ snmpget -p 8161 localhost public svCmpaErrorLastDesc.0

enterprises.stratacom.svplus.serviceGroup.connGroup.svCmpaErrorLastDesc.0 = "[11/24/2005 11:04:48] Port [1.0.1] not found"

Nevertheless, I can modify the same parameters on the end point:

bash$ snmpset -p 8161 localhost private atmEndPointSCRZeroPlus1.6.65.66.73.45.66.49.0.1.3.201.201 i 50

enterprises.stratacom.svplus.serviceGroup.connGroup.atmEndPointTable.atmEndPointEntry.atmEndPointSCRZeroPlus1."ABI-B1"."".1.3.201.201 = 50

Any help will be truly appreciated!

Thanks,

Juan Miguel

mnewnam05 · ‎11-29-2005

I'm not familiar with these models, but if an ATM card is used it must be seated before MIBs are populated.