Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CWM SNMP Agent: Modifying ATM-Fr middle end point parameters?

Hi,

I've been unsuccessfully trying to modify parameters for svConnMiddlEndPt on a ATM-FR connection between a BPX 8620 and a MGX 8230. Syntax seems to be correct, for I can thus modify parameters on the ATM 'final' end point:

bash$ snmpset -p 8161 localhost private atmEndPointSCRZeroPlus1.6.65.66.73.45.66.49.0.1.1.1.1 i 50

Error in packet.

Reason: (genError) A general failure occured

Failed object: enterprises.stratacom.svplus.serviceGroup.connGroup.atmEndPointTable.atmEndPointEntry.atmEndPointSCRZeroPlus1."ABI-B1"."".1.1.1.1

bash$ snmpget -p 8161 localhost public svCmpaErrorLastDesc.0

enterprises.stratacom.svplus.serviceGroup.connGroup.svCmpaErrorLastDesc.0 = "[11/24/2005 11:04:48] Port [1.0.1] not found"

Nevertheless, I can modify the same parameters on the end point:

bash$ snmpset -p 8161 localhost private atmEndPointSCRZeroPlus1.6.65.66.73.45.66.49.0.1.3.201.201 i 50

enterprises.stratacom.svplus.serviceGroup.connGroup.atmEndPointTable.atmEndPointEntry.atmEndPointSCRZeroPlus1."ABI-B1"."".1.3.201.201 = 50

Any help will be truly appreciated!

Thanks,

Juan Miguel

1 REPLY
New Member

Re: CWM SNMP Agent: Modifying ATM-Fr middle end point parameters

I'm not familiar with these models, but if an ATM card is used it must be seated before MIBs are populated.

113
Views
0
Helpful
1
Replies
CreatePlease to create content