Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Data Connectivity Using E1 ports of WAI-E1C-4RJ48 card

One of my customer is having WAI-E1C-4RJ48 [4 Port E1 (circuit emulation) RJ-48 PAM] card installed in Cat8540-MSR switch. Now they wants to use one of the four E1 (circuit emulation) port, for establishing a 2 MBPS E1 Data link for Internet access. I studied and found that these ports are primarily used for voice connection (connectivity with EPABX). Can you confirm whether it's possible to meet the customer's expectation with this setup??

1 REPLY
Bronze

Re: Data Connectivity Using E1 ports of WAI-E1C-4RJ48 card

I doubt if this setup meet's the customer's expectations.

186
Views
0
Helpful
1
Replies
CreatePlease to create content