I am doing a T-1 migration between two sites using Cisco 3825 routers and VWIC-2MFT modules with the integrated
CSU/DSUs at both ends. We're replacing 3620 routers with the WIC T-1 modules and external CSU/DSU's. The T-1 is provisioned already and has been working fine with the old routers.
My question has to do with clocking on the new VWIC MFT routers.
Do I set one router as source clock internal and the other router as source clock line? Right now this is how our CSU/DSUs are configured: source clock internal at one site and source clock line at the other site. Or do I use line on both ends?
Also, do I need to put in "no-network-clock-participate or "network-clock-participate." What's the difference?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...