Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Cisco Support Community site will be in read only mode on Dec14, 2017 from 12:01am PST to 11:30am for standard maintenance. Sorry for the inconvenience.

New Member

DCD=up DSR=down DTR=up RTS=up CTS=up but pinging

at remote-end router WAN interface it shows DCD=up DSR=down DTR=up RTS=up CTS=up and local-end router is fine with no error and everything is up and ping over this WAN connection to the remote network then what can be the cause of the remote-end DSR=down ?

1 REPLY
Hall of Fame Super Gold

Re: DCD=up DSR=down DTR=up RTS=up CTS=up but pinging

Check the the device connected to serial. Router is merely reporting the status of a pin.

1102
Views
0
Helpful
1
Replies
CreatePlease to create content