Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

DCD=up DSR=down DTR=up RTS=up CTS=up

Can anybody give me links from where i get meaning of

DCD=up DSR=down DTR=up RTS=up CTS=up

in details for troubleshooting prpose

Regards

Thanks

Mahesh

2 ACCEPTED SOLUTIONS

Accepted Solutions

Re: DCD=up DSR=down DTR=up RTS=up CTS=up

I think you should check the chapter on dialing solutions of the IOS configuration guide:

http://www.cisco.com/en/US/products/sw/iosswrel/ps5187/prod_configuration_guide09186a008017d8e6.html

Hope this helps you out.

Regards,

Leo

Silver

Re: DCD=up DSR=down DTR=up RTS=up CTS=up

Hi Majesh

DCD - This signal is output by the DCE to indicate that a valid carrier has been detected.

DTR - This signal is output by the DTE to indicate that it is ready for communication.

DSR - This signal is output by the DCE (in response to DTR) to indicate that it has been switched on and connected to the communications channel.

RTS - This signal is output by the DTE to indicate that it is ready to send data.

CTS - This signal is output by the DCE to acknowledge RTS and to indicate that it is ready for data transmission.

For troubleshooting this might help:

http://www.cisco.com/en/US/tech/tk713/tk628/technologies_tech_note09186a00800a758d.shtml

3 REPLIES

Re: DCD=up DSR=down DTR=up RTS=up CTS=up

I think you should check the chapter on dialing solutions of the IOS configuration guide:

http://www.cisco.com/en/US/products/sw/iosswrel/ps5187/prod_configuration_guide09186a008017d8e6.html

Hope this helps you out.

Regards,

Leo

Silver

Re: DCD=up DSR=down DTR=up RTS=up CTS=up

Hi Majesh

DCD - This signal is output by the DCE to indicate that a valid carrier has been detected.

DTR - This signal is output by the DTE to indicate that it is ready for communication.

DSR - This signal is output by the DCE (in response to DTR) to indicate that it has been switched on and connected to the communications channel.

RTS - This signal is output by the DTE to indicate that it is ready to send data.

CTS - This signal is output by the DCE to acknowledge RTS and to indicate that it is ready for data transmission.

For troubleshooting this might help:

http://www.cisco.com/en/US/tech/tk713/tk628/technologies_tech_note09186a00800a758d.shtml

New Member

Re: DCD=up DSR=down DTR=up RTS=up CTS=up

Thank you all for links

Regards

12633
Views
0
Helpful
3
Replies