Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Debug Output

I am using debug ip packet command with ACL on 7600 router but no output seen.

Is debug command with acl has issue?

1 REPLY

Re: Debug Output

Are you telnetting into the router?

If so don't forget the 'terminal monitor' command.

Also 'logging monitor 7' should be configured.

If you connected through the console, 'logging console 7' should be there.

Also are other debugs working/displaying?

Regards

Farrukh

107
Views
0
Helpful
1
Replies