Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

default-information originate between VRF's

I'm trying to have the default route from one VRF be imported into another VRF and then learned by the rest of the network on VRF.

Below is a basic configuration we are using. When using this configuation the default route that is being originated from the Intenret VRF is not apppearing in the WAN VRF. Is this possible? If so, can we also have the default route that the WAN VRF has imported be learned throughout the rest of the network which is either BGP or OSPF.

Thanks,

Mike

vrf definition Internet

rd 65000:40

route-target export 65000:40

!

address-family ipv4

exit-address-family

vrf definition WAN

rd 65000:60

route-target export 65000:60

route-target import 65000:40

!

address-family ipv4

exit-address-family

router bgp 65000

bgp log-neighbor-changes

!

address-family ipv4 vrf Internet

  network 10.0.40.0 mask 255.255.255.0

  default-information originate

exit-address-family

!

address-family ipv4 vrf WAN

  redistribute connected

  redistribute ospf 60

exit-address-family

!

ip route vrf Internet 0.0.0.0 0.0.0.0 10.0.40.1

Everyone's tags (4)
1 REPLY
New Member

default-information originate between VRF's

Hi,

i miss "redistribute static" under address-family ipv4 vrf Internet

I think to import a default route from one vrf to another is not possible. You have two different routing tables.

I configured a static default route for every vrf.

Horst

700
Views
0
Helpful
1
Replies