Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Default route problem.

Hi mates,

I have the following problem which I need your input.

We have a 1721 with 2 Ethernet and 1 fastethernet interfaces;

e0/0 - Connects to VSAT

e1/0 - connects to Remote site through wireless through local ISP.

FE - Connects to the LAN

Is it possible to have ip nat outside cmd on both e1/0 and e0/0 interfaces and have ip nat inside command FE?

If possible, what is the implication of having both? I have running into a situation where my default route cannot be changed to e0/0 even after defining it explicitly.

Thanks in advance for your help.

4 REPLIES
Hall of Fame Super Bronze

Re: Default route problem.

You sure can.

The implication depends upon applications used on these links. Some apps may have problem when the IP address is translated.

New Member

Re: Default route problem.

Thanks for your response. I would to know if there any parameters used to select between the two interfaces (e0/0 and e1/0) for translation .

Thanks

Hall of Fame Super Bronze

Re: Default route problem.

Can you elaborate ?

How much understanding you have regarding NAT ( grade yourself 1-10) ?

Re: Default route problem.

It would depend on the routing.

Narayan

100
Views
0
Helpful
4
Replies