03-20-2006 06:43 AM - edited 03-03-2019 12:06 PM
Hi All,
Just a clarification on an earlier post. When I implement iBGP in a few weeks, it will be done using the loopbacks on the PE and CE routers. One question I did have is about the default route statement.
I have seen on Cisco's site that the following should be added:
ip route <PE Loopback0> 255.255.255.255 <PE router>
How is this to be done when I have two Serial interfaces connecting to two on the other end. Do I have two of these commands? one for each serial address on the other end?
TIA,
R
Solved! Go to Solution.
03-20-2006 06:46 AM
You can indeed have two such commands with two different
Hope that helps - pls rate the post if it does.
Paresh
03-20-2006 06:46 AM
You can indeed have two such commands with two different
Hope that helps - pls rate the post if it does.
Paresh
03-20-2006 06:59 AM
Ok, thanks Paresh. I was unsure if it would indeed load balance if I was using CEF.
Thanks again!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: