03-20-2006 06:43 AM - edited 03-03-2019 12:06 PM
Hi All,
Just a clarification on an earlier post. When I implement iBGP in a few weeks, it will be done using the loopbacks on the PE and CE routers. One question I did have is about the default route statement.
I have seen on Cisco's site that the following should be added:
ip route <PE Loopback0> 255.255.255.255 <PE router>
How is this to be done when I have two Serial interfaces connecting to two on the other end. Do I have two of these commands? one for each serial address on the other end?
TIA,
R
Solved! Go to Solution.
03-20-2006 06:46 AM
You can indeed have two such commands with two different
Hope that helps - pls rate the post if it does.
Paresh
03-20-2006 06:46 AM
You can indeed have two such commands with two different
Hope that helps - pls rate the post if it does.
Paresh
03-20-2006 06:59 AM
Ok, thanks Paresh. I was unsure if it would indeed load balance if I was using CEF.
Thanks again!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide