Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Deployment configuration!

Guys

Have a look to the Attached file

how to configure the 4 MBps link on asa-1 to be just dedicated for the server on the dmz and other traffic goes via asa-2 ( link  2 mbps for browsing),project still on the draft,so what is ur suggestion from a to z

Thanks

6 REPLIES
Hall of Fame Super Blue

Re: Deployment configuration!

alsayed@litani.gov.lb

Guys

Have a look to the Attached file

how to configure the 4 MBps link on asa-1 to be just dedicated for the server on the dmz and other traffic goes via asa-2 ( link  2 mbps for browsing),project still on the draft,so what is ur suggestion from a to z

Thanks

Ali

If the firewalls are a pair then configure as active/active and have one context for the server and another context for the inside users.

If the firewalls are standalone simply set the server default-gateway to asa-1 and the internal users to asa-2.

Jon

Community Member

Re: Deployment configuration!

Thanks Jon,

pls Sample config for ur suggestions for both both...

Re: Deployment configuration!

Thanks Jon,

pls Sample config for ur suggestions for both both...

Check out the below link for Active/Active configuration of firewall

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a0080834058.shtml#lanbas

Hope to Help !!

Ganesh.H

Community Member

Re: Deployment configuration!

Jon and Ganesh.H

can 1 firewall with multiple context does the above scenario,e.g context per users and context for the server along with different link from different ISPs

if so how the prospective could be?

JON,congratulation for the gold start beside ur name

thanks

Re: Deployment configuration!

Jon and Ganesh.H

can 1 firewall with multiple context does the above scenario,e.g context per users and context for the server along with different link from different ISPs

if so how the prospective could be?

JON,congratulation for the gold start beside ur name

thanks

Hi,

Check out the below link for multiple context configuration as per your requirement with sample examples:-

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00808d2b63.shtml

Hope to help !!

Ganesh.H

Community Member

Re: Deployment configuration!

Thanks

265
Views
15
Helpful
6
Replies
CreatePlease to create content