Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Desperate NEED HELP ASAP

Hi,

I have an 1812 cisco router, and I have been trying to set this thing up for about a month now.

I am using SDM to setup the router but I am unable to set it up successfully.

My enviornment:

-I have a SBC DSL Connection

-Cisco 1812 router

So far via SDM, I have configured my VLan1 to the IP 192.168.1.1 255.255.255.0. My Fast Ethernet 0 or 1 is not setup yet.

Can someone help me setup my FE0 so that I may access the internet. Remember I connect to the internet using SBC DSL.

Please help

5 REPLIES
Community Member

Re: Desperate NEED HELP ASAP

Can you please clarify what exactly u want to do?

you want to route data from your router to the SBC DSL Connection Modem or what?

Community Member

Re: Desperate NEED HELP ASAP

Correct,

I want my cisco router 1812 to act as the main router for my DSL connection.

Right now I have the SBC DSL modem connected to the FE0 port via Cat 5. My computer is connected to port 2 via cat 5.

Please help!!!!

Community Member

Re: Desperate NEED HELP ASAP

scenario is still not explained. do you have single computer or you want internet on multiple computers.

Community Member

Re: Desperate NEED HELP ASAP

I want the internet on multiple computers, I will connect all of my computers via the 1812. Please let me know if you need more information and thanks for the help thus far

Community Member

Re: Desperate NEED HELP ASAP

hi

you need to use NAT on the router. use following commands

int fa0 ( interface connected to internet)

ip nat outside

int fa1

ip nat inside

ip access-group 150 in

ip nat inside source list 150 interface fa0 overload

access-list 150 permit ip any any

126
Views
0
Helpful
5
Replies
CreatePlease to create content