Status : Last write failed because of a protocol error.
Delay : 120 seconds
Timeout : 300 seconds
Failures : 30
I cannot figure out what is the reason for this. But I can assure my ftp server working fine and the ftpuser can write data to the particular directory. I have tow interfaces in my router. Because of this I need to provide souce interface as my LAN IP. How can define it during this command. For a example in syslog messages i defined the "logging source fa 0/0" command.
your responses are higly welcome in order to solve this.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...