i have scenario that there is clients in remote branch take IP's from DHCP server In HQ i need to configure remote branch router to act as Backup DHCP server in case of link down between H.O and Branch. Please send me configuration required to acheive that on the router
Just configure the branch router for DHCP. In HQ router you need to make it the default DHCP router. Add the below command in HQ router. Its own IP is address1(primary) and second IP is of branch router. This will solve your problem.
address [address2 ... address8]
(Specifies the IP address of the default router for a DHCP client.
One IP address is required, although you can specify up to 8 addresses in one command line.)
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...