I have two 1242's one as a AP the other as a workgroup bridge. I want to run DHCP between the two devices (not necessarily using either as the DHCP server) but I don't know how. I don't see anything in the GUI that allows for this but maybe there is something in the IOS that can be done from the console.
Also, when I try to setup a VLAN between the two, using Native, my Cisco 186 ATA's start performing poorly. Sometimes the phone rings, sometimes it doesn't. Remove the VLAN, works perfect. Any suggestions?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.