Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

DHCP relay, IP address range in use verification

Pls. can some explain to me how to investigate the IP range my cisco (AIRONET-AP)AP is using with CLI. Betterstill, with the GUI- web interface, investigation is also possible. thanks

1 REPLY
Silver

Re: DHCP relay, IP address range in use verification

When you configure the AP as a DHCP server, IP addresses are assigned to devices that are on the same subnet as the DHCP server. The devices communicate with other devices on the subnet, but do not communicate beyond the subnet. If you need to pass data beyond the subnet, you must assign a default router. The IP address of the default router should be on the same subnet as the AP that you configured as the DHCP server.

Follow the URL which will help you :

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a00808714fe.shtml

204
Views
0
Helpful
1
Replies
CreatePlease to create content