I'm trying to configure dhcpv6, and it's not working. When I run wireshark I see absolutely nothing from my host requesting an address. I get the link local of the router interface, but that's it. I have the following configured:
ipv6 dhcp pool TEST
no ip address
ipv6 address 2001::2/48
ipv6 nd other-config-flag
ipv6 dhcp server TEST
I have my host directly connected to fa0/0 via crossover cable. I can ping the v6 address, but I'm not getting a global address from the pool. I've tried the prefix-delegation command like:
prefix-delegation 2001::/48 <random numbers>
It's not working, and I can't figure out why. I've followed Cisco's doc, but at one point it says that configuring dhcpv6 client is required, but I'm not requesting an address from anything else.
Has anyone done this before, and can you see where I went wrong?
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...