Dialer interface doesnt support dialer map command???
greetings to all,
I have an 876 router with ISDN as a backup (in a dialer profile interface)
I am facing the following issue. I try to configure 'dialer map' from interface dialer0 and the router doesnt support it, i.e. it doesnt have it as a command! It can only understand 'dialer string' commands which are inadequate since i have two peers to communicate...
I can only configure them through bri interface but since i am using dialer profile i know that this is not correct.
Any suggestions? If i configure them in bri int will it work?
Re: Dialer interface doesnt support dialer map command???
I still prefer dialer map command when supported as I explained in the other thread.
However, just in these days a collegue of mine has prepared an 800 with IDN using multiple dialer string commands and multiple username passwords pairs and it tested it with good results when the objective is just redundancy for the default route.
The real trouble comes when a different routing would be required to the different peers.
I'm afraid this is not possible without using the dialer map command
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...