Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Dialer Interface - Increasing OQD

Hi guys,

Currently I having slow network issue on two separate routers(CISCO1941/K9) with it's own individual broadband connection.

Both shares the same IOS (Version 15.2(4)M5) and same OQD errors.

Below are the interface summary and error log.

  Interface                   IHQ       IQD       OHQ       OQD      RXBS      RXPS      TXBS      TXPS      TRTL

-----------------------------------------------------------------------------------------------------------------

  Em0/0                         0         0         0         0         0         0         0         0         0

* GigabitEthernet0/0            0         0         0         0  17709000      2890   1990000      1260         0

* Gi0/0.500                     -         -         -         -         -         -         -         -         -

* GigabitEthernet0/1            0         1         0       364   1911000      1260  17069000      2824         1

* Dialer1                       0       182         0     90569  17153000      2886   1716000      1215         0

* NVI0                          0         0         0         0         0         0         0         0         0

* Virtual-Access1               0         0         0         0         0         0         0         0         0

* Virtual-Access2               0         0         0         0  17157000      2887   1751000      1260         0

NOTE:No separate counters are maintained for subinterfaces

     Hence Details of subinterface are not shown

*Feb 17 00:58:11.692: %IP_VFR-4-FRAG_TABLE_OVERFLOW: Dialer1: the fragment table has reached its maximum threshold 16.

Can I know whether by upgrading to T version helps to solve the OQD errors?

And is it possible to upgrade the IOS from a M version to a T version?

158
Views
0
Helpful
0
Replies
CreatePlease to create content