05-19-2007 06:26 PM - edited 03-03-2019 05:03 PM
Hi, how do you find out which interface is being used when you are using dialer group with multiple interfaces in the group?
Is there some sort of show command that tells you? I have tried "show int dialer 1" but it only tells me the virtual interface which the dialer is bound to and not the physical interface that is being used to make the connection.
Any information would be greatly appreciated. Thank you.
05-20-2007 11:21 AM
Hi,
If I remember correct use this command:
sh ppp multilink.
HTH
Regards,
Bjornasrb
05-20-2007 04:45 PM
Hi, sorry this does not show the information that I am after but thank you for the suggestion though.
05-20-2007 08:27 PM
Hi
can you try show isdn active and check ?
regds
05-20-2007 08:34 PM
This may work when ISDN interfaces are part of the pool but what happens if an ATM, ethernet or serial interface is being used? Thank you for your suggestion.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: