Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Dialer pools - Checking which interface is being used

Hi, how do you find out which interface is being used when you are using dialer group with multiple interfaces in the group?

Is there some sort of show command that tells you? I have tried "show int dialer 1" but it only tells me the virtual interface which the dialer is bound to and not the physical interface that is being used to make the connection.

Any information would be greatly appreciated. Thank you.

4 REPLIES
Bronze

Re: Dialer pools - Checking which interface is being used

Hi,

If I remember correct use this command:

sh ppp multilink.

HTH

Regards,

Bjornasrb

New Member

Re: Dialer pools - Checking which interface is being used

Hi, sorry this does not show the information that I am after but thank you for the suggestion though.

Re: Dialer pools - Checking which interface is being used

Hi

can you try show isdn active and check ?

regds

New Member

Re: Dialer pools - Checking which interface is being used

This may work when ISDN interfaces are part of the pool but what happens if an ATM, ethernet or serial interface is being used? Thank you for your suggestion.

118
Views
0
Helpful
4
Replies