Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

dialup multilink issue

i have an nm-8am module on the router and planning to use 2 of the async port as backup of my existing frame relay..

we want this 2 dialup to come up at the same time and remain up all the time unless the frame relay comes up again.

please tell me how to configure this.

thanks a lot

1 REPLY
86
Views
0
Helpful
1
Replies
CreatePlease to create content