OSPF stub routers are little different than eigrp stub routers.
IN OSPF stub routing you will block the LSA 4,5,6 and 7 in stub routers but in EIGRP there is no conecpt of LSA,s.
IN EIGRP normally we use the concept of stub routing in hub and spoke technology.
WE will configure the spoke routers as the stub routers. When we will configure the spoke routers as stub routers they will send the packets to the neighbors telling that they are configured as aa stub routers.
SO when the neighbors will get the information they will not send any query to the stub routers. it will save the bandwidth.
Hub routers will send a default route to the spoke roters to reach the hub routers.
Command to configure stub routing:-
There are follwing switches to the command.
1.)receive-only :- stub routers will only receive the data.
2.)connected :- stub routers will send the connected routes.
3.) static:- stub router will send the static route information to hub routers.
4.) summary:- stub router will send the summary routes.
By default the configuration enabled is connected and summary.
Hope you liked my explanarion.
P.S:- Don,t forget to rate the post if u ll find it informative.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.