Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Differences between sintax "SHDSL0" and "SHDSL0/0/0"

Until you have single WAN, the problem doesn't exist;

but when you have to configure multiple WANs, born the issue.

In specific I'm speaking about the CISCO888-EA-K9.

System image file is "flash:c800-universalk9-mz.SPA.153-2.T.bin"

Normally you can add a controller SHDSL 0 or SHDSL 0/0/0 (although the ios onboard doesn't support the last sintax);

I have a conf the shows how another 888 is configured with SHDSL 0/0/0 + SHDSL 0/1/0, but I can't do the same with SHDSL 0 + SHDSL 0.1

     Router(config)#controller shDSL 0.1

                                 ^

     % Invalid input detected at '^' marker.

     Router(config)#controller shDSL 0/1/0

                                 ^

     % Invalid input detected at '^' marker.

Where is my error?

Thanks for your support.

  • WAN Routing and Switching
3 REPLIES
Hall of Fame Super Gold

Differences between sintax "SHDSL0" and "SHDSL0/0/0"

I don't see how you can add another controller or interface. 880 routers are fixed configuration.

New Member

Differences between sintax "SHDSL0" and "SHDSL0/0/0"

Salve Paolo,

mi sono fato inoltrare una running-config da Wind (Provider in questione), che mostra:

!

multilink bundle-name authenticated

license udi pid C888EA-K9 sn xxx

license boot module c800 level advipservices

!

!

!

!

!

!

!

controller SHDSL 0/0/0

mode efm

dsl-group 0 pairs 0

!

!

!

controller SHDSL 0/1/0

mode efm

dsl-group 0 pairs 0

!

!

!

!

interface Ethernet0/0/0

description 2Mb shdsl ULL xxx

no ip address

no shut

!

interface Ethernet0/0/0.3909

description efm

encapsulation dot1Q 3909

ip address x.x.x.x 255.255.255.252

!

!

!

interface Ethernet0/1/0

description 2Mb shdsl ULL xxx

no ip address

no shut

!

interface Ethernet0/1/0.3406

description efm

encapsulation dot1Q 3406

ip address x.x.x.x 255.255.255.252

!

!

interface Vlan1

ip address x.x.x.x 255.255.255.248

ip virtual-reassembly in

!

Hall of Fame Super Gold

Re: Differences between sintax "SHDSL0" and "SHDSL0/0/0"

That config is not from an 880 router.

You need to use controller and interface numbers as your router have.

175
Views
0
Helpful
3
Replies