Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Direct connect method to test T1 router configuration prior to installation

What cable or devices are required to directly connect a 3845 ISR via a T1 WIC card to an 1841 WIC card to test the configuration prior to installation? I have both devices configured, but am unable to get a link light using a CAT 6, Cat 5e crossover, or flat cable from an old Adtran.

2 REPLIES
VIP Super Bronze

Re: Direct connect method to test T1 router configuration prior

Hello,

You would need T1 cross over cable.(Rj45)

Check out this site for specific pin configuration

http://www.ecst.csuchico.edu/~dranch/HARDWARE/common-cables.html#xover-t1

Also for where to buy your cable:

http://www.stonewallcable.com/product.asp?dept%5Fid=134&pf%5Fid=SC%2D9598%2DX

HTH

Reza

Community Member

Re: Direct connect method to test T1 router configuration prior

Made up a T1 crossover cable per the provide link and it worked, Thanks

623
Views
0
Helpful
2
Replies
CreatePlease to create content