There are several small routers connected to my hub-router, talking RIPv2 between eachother.
I have configured a distribute-list with prefix-list, because I don't want routes to be announced to the spoke routers. Via the prefix-list I have configured that only a default-route is announced that I get from my OSPF cloud.
But when I do a debug when a topology change takes place, I can see that there are still flash-updates towards my spokes, that should be filtered out by the lists.
When using a distribute-list and prefix-list, flash updates should be filtered out too?? right?
Without a few specifics it is difficult to know how to best answer your question. If you could proivde the RIP configuration and the distribute list and the prefix list it would give us something to start from. It would also be helpful if you would post the debug output that you are seeing.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.