Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

DMVPN dual hub config issues

Hey Guys.

I have a 3 spokes right now and two hubs. The other day I rebooted one of the hubs and noticed that I had lost the tunnels to all of my spokes. I thought they would continue routing through the head end that was still up but that wasn't the case. Any ideas (see spoke config below)

interface Tunnel10

ip address x.x.x.x x.x.x.x

no ip redirects

ip mtu 1400

ip nhrp authentication abc123

ip nhrp map multicast x.x.x.x

ip nhrp map multicast x.x.x.x

ip nhrp map x.x.x.12 x.x.x.x

ip nhrp map x.x.x.13 x.x.x.x

ip nhrp network-id 200

ip nhrp nhs x.x.x.12

ip nhrp nhs x.x.x.13

ip tcp adjust-mss 1360

no ip split-horizon eigrp 100

tunnel source Fastethernet4

tunnel mode gre multipoint

tunnel key 1234

tunnel protection ipsec profile spokes

3 REPLIES
Silver

Re: DMVPN dual hub config issues

B Rockburn,

Are the spokes normally sending/receiving traffic via the hub that you rebooted, and you was expecting the secondary hub to takeover?

Ajaz

Hall of Fame Super Silver

Re: DMVPN dual hub config issues

Hello Brent,

you should provide also the configuration of the two hubs, of the eigrp routing processes and the isakmp config ( focus on isakmp keepalive settings)

you have two hubs in the same DMVPN cloud it is important to daisy chain the NHRP configurations on the two hubs so that each sees the other as an NHRP server

Hope to help

Giuseppe

Community Member

Re: DMVPN dual hub config issues

Thanks I didn't have them pointing to eachother so that probably didn't help.

I'll try it out and let you know.

156
Views
0
Helpful
3
Replies
CreatePlease to create content