Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

DMVPN - Ping fails on LAN to LAN

Hi Experts - Seeking your help to understand why I am not able to ping the HUB LAN IP address from Spoke LAN IP address in a DMVPN setup. It is a new installation I am trying to achieve.

 

1. Ping successful when doing from spoke to Hub Tunnel IP (ping <hub-Tunnel IP address>)

2. Ping fails when doing from spoke to Hub Tunnel IP using source Interface as LAN IP add (ping <hub-Tunnel IP address> source <fa 0/0)

3. Ping fails when doing from spoke to Hub fa 0/0  using source Interface as LAN IP add (ping <hub-Tunnel IP address> source <fa 0/0)

 

What is the general reason for this. The output from Router below. Can you help me please. Thanks in advance

 

regards / SAIRAM

 

 

debug

HUB#
*Mar  1 03:02:45.107: NHRP: MACADDR: if_in null netid-in 0 if_out Tunnel0 netid-out 1
*Mar  1 03:02:45.107: NHRP: Checking for delayed event 0.0.0.0/192.168.2.1 on list (Tunnel0).
*Mar  1 03:02:45.107: NHRP: No node found.

 

Config

HUB#

interface Tunnel0
 ip address 172.16.1.1 255.255.255.0
 no ip redirects
 ip nhrp map multicast dynamic
 ip nhrp network-id 1
 tunnel source 127.11.100.1
 tunnel mode gre multipoint
end

interface FastEthernet0/0
 ip address 152.141.1.85 255.255.255.0
 

ip route 192.168.2.0 255.255.255.0 Tunnel0
 

SPOKE#

interface Tunnel1
 ip address 172.16.1.2 255.255.255.0
 no ip redirects
 ip nhrp map 172.16.1.1 63.11.124.5
 ip nhrp network-id 1
 ip nhrp nhs 172.16.1.1
 tunnel source 208.11.121.3
 tunnel mode gre multipoint
end

ip route 152.141.0.0 255.255.0.0 Tunnel1
 

interface FastEthernet0/0
 ip address 192.168.2.1 255.255.255.0



 

  • WAN Routing and Switching
2 REPLIES
New Member

I noted when I am configuring

I noted when I am configuring the spoke LAN IP address statically in NHRP, I am able to ping from Spoke LAN to Hub LAN.

ip nhrp map <Spoke LAN IP address> <Spoke Tunnel IP address>

 

But how to make it using Dynamically learn?

 

regards / SAIRAM

 

Cisco Employee

What was the resolution ?

What was the resolution ?

436
Views
0
Helpful
2
Replies
This widget could not be displayed.