Does anyone know why we have so many NAT entries as below ?
We are running DMVPN EIGRP topology in our network. The DMVPN hub aggregates all the spoke router networks via the tunnel. ALso the Spoke routers allow internet traffic by using NAT and only private traffic flows through the DMVPN tunnel. The IPSec is up and running fine and EIGRP works good. Serial int overload for NAT is configured.
Brief configs on Hub and Spoke are as below:
description VPN tunnel
ip address 172.28.1.159 255.255.252.0
ip nhrp authentication xxx
ip nhrp map 172.28.1.1 6x.xx.x.x
ip nhrp network-id 100000
ip nhrp holdtime 360
ip nhrp nhs 172.28.1.1
ip summary-address eigrp 100 10.159.0.0 255.255.0.0 5
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...