I have one hub and two spokes configured with multipoint GRE on each router. IPsec comes up between hub and each spoke and "show ip nhrp" and "show crypto isakmp sa" show two spokes on hub router. Now I need to see that spoke to spoke communicate directly without a hub in between. How can I do that? Ping any LAN IP on spoke side? I tried that but traceroute still shows hub in between. What I can do to make spoke to spoke communicate directly? Is there anything extra needed?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...