10-31-2011 07:09 PM - edited 03-04-2019 02:06 PM
Hi,
Catalyst 4900m does not support command "ip sla <entry-number>" like Catalyst 6500. If 4900 does support SLA, how to configure it then?
Switch(config)#ip sla ?
key-chain Use MD5 authentication for IP SLAs control message
responder Enable IP SLAs Responder
Switch#sh ver
Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500e-IPBASE-M), Version 12.2(53)SG2, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2010 by Cisco Systems, Inc.
Compiled Tue 16-Mar-10 02:39 by prod_rel_team
Image text-base: 0x10000000, data-base: 0x1240D93C
ROM: 12.2(44r)SG5
Darkside Revision 0, Jawa Revision 11, Tatooine Revision 140, Forerunner Revision 1.78
Switch uptime is 2 weeks, 4 days, 6 hours, 31 minutes
System returned to ROM by power-on
System image file is "bootflash:cat4500e-ipbase-mz.122-53.SG2.bin"
cisco WS-C4900M (MPC8548) processor (revision 2) with 524288K bytes of memory.
Processor board ID JAE150800ZJ
MPC8548 CPU at 1.33GHz, Cisco Catalyst 4900M
Last reset from PowerUp
1 Virtual Ethernet interface
40 Gigabit Ethernet interfaces
8 Ten Gigabit Ethernet interfaces
511K bytes of non-volatile configuration memory.
Configuration register is 0x2101
thx,
Shelley
Solved! Go to Solution.
11-02-2011 06:04 AM
Sorry - my bad. Try now:
http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/53SG/configuration/swipsla.html
If this was helpful you can rate for other to use it in future.
Nik
10-31-2011 07:54 PM
Hello,
IP SLA is supported in 12.2(53)SG - the release you use but not in ipbase image. Ipbase supports only responder functions as you saw.
Here is the relase:
"
Note Switches running the IP base image support only IP SLAs responder functionality and must be configured with another device that supports full IP SLAs functionality, for example, a switch.
"
Enterprise image should definitely support it but you can check further in Cisco feature navigator to see all the other features you need:
http://tools.cisco.com/Support/Fusion/sfselectmdf.do?mySession=422560&myStep=7
Hope this helps,
Nik
11-01-2011 11:48 AM
Hi Nik,
You are right. By the way, I cannot access the configuration link for Cat 4500.
thx,
Shelley
11-02-2011 06:04 AM
Sorry - my bad. Try now:
http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/53SG/configuration/swipsla.html
If this was helpful you can rate for other to use it in future.
Nik
11-02-2011 10:42 AM
Hi Nikolay,
Thanks for all your help!
shelley
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: