I know by doing the, frame-relay map ip <x.x.x.x> (dlci #) broadcast routing protocols work in my lab inside of packet tracer. But when I was just doing inverse arp dynamically, "Serial0/0 (up): ip 184.108.40.206 dlci 25, dynamic, broadcast, CISCO, status defined, active" the routing protocols do not work. Is there a way to have inverse arp to work with broadcast?
Cool, i'll read it in just a big. Would you also happen to know if a cloud in Packet Tracer is able to work from point-to-point (sub interfaces) frame relay networks? I am attempting it and I can't get the cloud to except more then a few mappings of the sub interfaces dlci's so only half of it works, the rest I get an error message
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...