Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Does this "sh DSL int atm 0" look right?

Hi, I have an office on a VPN DSL line of 1mb downstream and 288kmps upstream and the ms can be around 500. Before we upgrade the line can you see anything wrong with this output?

sh dsl interface atm 0


Alcatel 20190 chipset information


Modem Status: Showtime (DMTDSL_SHOWTIME)

DSL Mode: ITU G.992.1 (G.DMT) Annex A

ITU STD NUM: 0x03 0x2

Vendor ID: 'STMI' 'TSTC'

Vendor Specific: 0x0000 0x0000

Vendor Country: 0x0F 0xB5

Chip ID: C196 (0)

DFE BOM: DFE3.0 Annex A (1)

Capacity Used: 61% 38%

Noise Margin: 9.0 dB 22.0 dB

Output Power: 15.5 dBm 12.0 dBm

Attenuation: 55.0 dB 27.5 dB

Defect Status: None None

Last Fail Code: None

Watchdog Counter: 0x3D

Watchdog Resets: 0

Selftest Result: 0x00

Subfunction: 0x00

Interrupts: 12384 (0 spurious)

PHY Access Err: 0

Activations: 1

LED Status: ON

LED On Time: 100

LED Off Time: 100

Init FW: init_AMR-3.0.014_no_bist.bin

Operation FW: AMR-3.0.014.bin

FW Source: embedded

FW Version: 3.0.14

Interleave Fast Interleave Fast

Speed (kbps): 0 1152 0 288

Cells: 0 5317638 0 1545657

Reed-Solomon EC: 0 0 1 4

CRC Errors: 0 1966 5 0

Header Errors: 0 1049 6 3

Total BER: 0E-0 1842E-9

Leakage Average BER: 0E-0 5366E-10


Bitswap: enabled enabled

Bitswap success: 0 0

Bitswap failure: 0 0

LOM Monitoring : Disabled

Hall of Fame Super Gold

Re: Does this "sh DSL int atm 0" look right?

Nothing is wrong and you are running recent firmware, that is good.

Hope this helps, please rate post if it does!