Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Domain server problem

ping http://www.google.com

Translating "www.google.com"...domain server (xxx.xxx.xxx.xxx) [OK]

Translating "www.google.com"...domain server (xxx.xxx.xxx.xxx) [OK]

Translating "www.google.com"...domain server (xxx.xxx.xxx.xxx) [OK]

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 203.106.203.238, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 1/2/4 m

this is a Cisco 7206VXR using c7200-p-mz.124-12.bin. When ping to http://www.google.com, the domain server translation repeat appeared few times. It suppose to be appear one time only, right? Do you guy have any idea what cause it?

5 REPLIES

Re: Domain server problem

HI Jackie,

This is Normal. Refer the"show run" whether the domain name-lookup is configured for some Servers then it may resolve quickly.

Otherwise check with the ISP for some DNS Names.

Do Rate if HELPS

Best Regards,

Guru Prasad R

New Member

Re: Domain server problem

ya,the domain name-lookup is configured, the config is

ip domain name xx.xx.x

ip name-server xxx.xxx.xxx.xxx

but on the other router also the domain name-lookup is configured, the config is

ip domain name xx.xxx.xx

ip name-server xxx.xxx.xxx.xxx

ip name-server xxx.xxx.xxx.xxx

but whe ping www.google.com it appear

ping www.google.com the domain translation is just appear 1 time only. And why it repeat several time on the other router

Translating "www.google.com"...domain server (202.188.1.5) [OK]

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 64.233.189.104, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 56/56/60 ms

Re: Domain server problem

HI Jackie,

If the name Server located in Service Provider means, i would recommend check with them for Resolution.

Whether the lookup Servers are Primary or relay points.

Try to trace the name Server from the Router in which you have the Problem and from the other U dont have.

Do Rate if HELPS

Best Regards,

Guru Prasad R

New Member

Re: Domain server problem

hi Guru Prasad R

thanks for the reply

but I do not understand the meaning of "Resolution" and what is the look servers?

New Member

Re: Domain server problem

hi Guru Prasad R

thanks for the reply

but I do not understand the meaning of "Resolution" and what is the "lookup servers"?

338
Views
0
Helpful
5
Replies