Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Cisco Support Community site will be in read only mode on Dec14, 2017 from 12:01am PST to 11:30am for standard maintenance. Sorry for the inconvenience.

New Member

dot1.q on ethernet subinterfaces

Hi, I have a cisco2611 running IOS Version 12.0(9)that doesn't support dot1.q. Can anyone advise me the correct IOS that support this feature

Regards

1 REPLY
Cisco Employee

Re: dot1.q on ethernet subinterfaces

Hi Maqed,

Basically you need a feature set in that particular IOS which you are running. You must be running IP Base feature set in release 12.0(9) so if you upgrade your router with same release 12.0(9) but with Ip Plus feature set you will get it working.

So while downloading IOS version jus check if that is having Ip Plus feature set.

HTH

Ankur

*Pls rate all helpfull post

93
Views
0
Helpful
1
Replies
CreatePlease to create content