I am trying to sole the same issue described below where users who are VPNing to corporate need to get to DMZ off an ISR with ZBPF. The IP address of the resource is the same internally and externally. The question I have is double-nat such as described in the article below ok on IOS firewall and is it the best solution to the problem? As noted - you could solve the issue by having a separate internal DNS but we'd rather not go down that route. Thank-you.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...