Been using DPC3925 provided by my service provider here in Singapore (Starhub). Have used 3 different telephone brands but still have the same issue: the line remains connected (with busy signal) even after the other party hangs-up already. I suspect the router/modem is not sending the correct disconnect (calling party control) signal to the phone. Appreciate your valuable inputs & advice.
Brought my telephone units to my friend, who uses another service provider with different voice modem. My telephone units work perfectly there. So this further confirms the issue is from Cisco DPC3925 router/modem.
Cisco, please check this & provide the fix ASAP!...
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...