I am working on my first Disaster Recovery project and am having trouble with the concept of the whole thing.. Does anyone know where I can find some examples of Disaster Recovery models using NAT at the DR site?
Thanks for the response. This doc as some good information.
This DR will not be a permenant DR but rather a test. I wil need to stand up a network that is exactly like the current network without interrupting the current traffic at the permanent data center.
To do this there will be a .test url for the new servers. The servers on the DR will have the same ips and NAT will be used to staticaly assign to those ips.. at least that is the plan. I am just not sure how that Nating will actually work and how to ensure traffic at the permanent data center will not be affected.
Have you seen and info on these types of scenarios...
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...