Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

ds0-group

how to use the ds0-group command to filter out the perticular DS0 from T1 and is there any link for CSU/DSU to terminate DS0 to convert it in to the HDLC encapsulation

regards

Devang

3 REPLIES
Bronze

Re: ds0-group

Hi,

I'm actually used to E1's and you have to set framing for the whole controller.

I quess its the same for T1's

BR,

Bjornarsb

Re: ds0-group

will you please explain the detail scenario where and how are you using this ds0-group with different encapsulation types?

Hall of Fame Super Gold

Re: ds0-group

You define ds-group to have as many timeslots as given by the service provider.

After that Channelized interfaces gets created and you set the desired encapsulation, if different encapsulation than hdlc is used.

That's really all about it.

104
Views
0
Helpful
3
Replies